Content:
1 piece pressure reducer 1 bar
consisting of two-part housing firmly screwed and ready for operation with union nut + strainer with sealing ring
The pressure reducer decreases the pressure in the supply line by means of a membrane + a defined spring set in a ratio of 4:1 as standard; with an inlet pressure of 4 bar, approx. 1 bar is achieved at the outlet; with larger systems, a line loss of up to 0.8 bar can still result. The unit is connected to the water tap, the water tap remains open. Even with a normal pump supply, the pressure must usually be reduced. The pressure reducer is largely maintenance-free, but it must be stored frost-free over winter.
Dimensions: diameter 71 x 88 mm, connection tap 3/4 inch internal thread. Material: PS + ASA plastics (acrylic styrene) + stainless steel parts
Connection for supply hose: removable compression fitting, connection grommet 1x 6/7.5 mm, with union nut for manual operation, diameter 16 x 14 mm.
Connection capacity with sufficient pressure (1 bar): with 1 supply line (one-sided connection) and 60 m hose length 250 drip points, with 2 supply lines (central connection with two directions) with 2x 60 m hose length 500 drip points.
Pre-pressure: max. 6 bar
Pressure variants: 3603 Pressure reducer 1.3 bar for supply at heights of 3 m and more (e.g. 2nd floor);
3606 Pressure reducer 0.5 bar for supply at low levels up to max. approx. 5 m height difference, also specially suitable for the soaker hose 'BlueSoak', also suitable for a secondary reduction of certain sections in 1 bar systems.
Connections: 30405 Supply hose 8 mm (and others)
Product safety information
Manufacturer information:
Blumat GmbH & Co. KG
Hag 7
Tirol
Telfs, Österreich, 6410
www.blumat.com
